MC34063A, MC33063A, SC34063A, SC33063A, NCV33063A
ELECTRICAL CHARACTERISTICS (V CC = 5.0 V, T A = T low to T high [Note 4], unless otherwise specified.)
Characteristics
Symbol
Min
Typ
Max
Unit
OSCILLATOR
Frequency (V Pin 5 = 0 V, C T = 1.0 nF, T A = 25 ° C)
Charge Current (V CC = 5.0 V to 40 V, T A = 25 ° C)
Discharge Current (V CC = 5.0 V to 40 V, T A = 25 ° C)
Discharge to Charge Current Ratio (Pin 7 to V CC , T A = 25 ° C)
Current Limit Sense Voltage (I chg = I dischg , T A = 25 ° C)
f osc
I chg
I dischg
I dischg /I chg
V ipk(sense)
24
24
140
5.2
250
33
35
220
6.5
300
42
42
260
7.5
350
kHz
m A
m A
?
mV
OUTPUT SWITCH (Note 5)
Saturation Voltage, Darlington Connection
( I SW = 1.0 A, Pins 1, 8 connected)
Saturation Voltage (Note 6)
(I SW = 1.0 A, R Pin 8 = 82 W to V CC , Forced b ] 20)
DC Current Gain (I SW = 1.0 A, V CE = 5.0 V, T A = 25 ° C)
Collector Off ? State Current (V CE = 40 V)
V CE(sat)
V CE(sat)
h FE
I C(off)
?
?
50
?
1.0
0.45
75
0.01
1.3
0.7
?
100
V
V
?
m A
COMPARATOR
Threshold Voltage
T A = 25 ° C
T A = T low to T high
Threshold Voltage Line Regulation (V CC = 3.0 V to 40 V)
MC33063, MC34063
MC33063V, NCV33063
Input Bias Current (V in = 0 V)
V th
Reg line
I IB
1.225
1.21
?
?
?
1.25
?
1.4
1.4
? 20
1.275
1.29
5.0
6.0
? 400
V
mV
nA
TOTAL DEVICE
Supply Current (V CC = 5.0 V to 40 V, C T = 1.0 nF, Pin 7 = V CC ,
V Pin 5 > V th , Pin 2 = GND, remaining pins open)
I CC
?
?
4.0
mA
IC driver – 7.0 mA *
4. T low = 0 ° C for MC34063, SC34063; ? 40 ° C for MC33063, SC33063, MC33063V, NCV33063
T high = +70 ° C for MC34063, SC34063; + 85 ° C for MC33063, SC33063; +125 ° C for MC33063V, NCV33063
5. Low duty cycle pulse techniques are used during test to maintain junction temperature as close to ambient temperature as possible.
6. If the output switch is driven into hard saturation (non ? Darlington configuration) at low switch currents ( ≤ 300 mA) and high driver currents
( ≥ 30 mA), it may take up to 2.0 m s for it to come out of saturation. This condition will shorten the off time at frequencies ≥ 30 kHz, and is
magnified at high temperatures. This condition does not occur with a Darlington configuration, since the output switch cannot saturate. If a
non ? Darlington configuration is used, the following output drive condition is recommended:
IC output
Forced b of output switch : w 10
* The 100 W resistor in the emitter of the driver device requires about 7.0 mA before the output switch conducts.
http://onsemi.com
3
相关PDF资料
MC34063LINVEVB EVAL BOARD FOR MC34063LINV
RE-1524S/H CONV DC/DC 1W 15VIN 24VOUT
A9CAG-0404F FLEX CABLE - AFG04G/AF04/AFE04T
GMC05DRTH-S13 CONN EDGECARD 10POS .100 EXTEND
A9BBA-0204F FLEX CABLE - AFF02A/AF02/AFF02A
L-07C15NJV6T CER INDUCTOR 15NH 0402
A9BAG-0506F FLEX CABLE - AFF05G/AF05/AFE05T
A9AAT-1503F FLEX CABLE - AFE15T/AF15/AFE15T
相关代理商/技术参数
MC34063U 制造商:Motorola Inc 功能描述: 制造商:Motorola Inc 功能描述:1.5 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, CDIP8
MC34064 制造商:MICROSEMI 制造商全称:Microsemi Corporation 功能描述:UNDERVOLTAGE SENSING CIRCUIT
MC34064D-005 功能描述:监控电路 4.59V UnderVoltage RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟(典型值):10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MC34064D-005G 功能描述:监控电路 4.59V UnderVoltage Sensing Circuit RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟(典型值):10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MC34064D5 制造商:ON Semiconductor 功能描述:VOLT SENSE CCT SMD 34064 SOIC8
MC34064D-5 制造商:ON Semiconductor 功能描述:
MC34064D-5G 功能描述:监控电路 4.59V UnderVoltage Sensing Circuit RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟(典型值):10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel
MC34064D-5R2 功能描述:监控电路 4.59V UnderVoltage RoHS:否 制造商:STMicroelectronics 监测电压数: 监测电压: 欠电压阈值: 过电压阈值: 输出类型:Active Low, Open Drain 人工复位:Resettable 监视器:No Watchdog 电池备用开关:No Backup 上电复位延迟(典型值):10 s 电源电压-最大:5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:UDFN-6 封装:Reel